| CTX/CIX
100,100S Rechargable |
(INSKIN)
BatterySupply |
 |
-
Install CTX/CIX 100 or 100s unto your backboard.
Make sure to secure the system as securely as
possible to help compensate for the extra wieght
of the battery backup.
- Remove
left side cover and top cover of the telephone
system.
-Install
ABCS card according to the Toshiba Installation
and Maintenance Manual.
|
|
|
-
While holding the battery backup with the tail
facing the backboard, gently insert the back flange
of the battery backup ontop of the rear horizontal
wall of the telephone system. The side closest
to the backboard of the battery backup should
'sit' on horizontal wall.
- While
keeping the back tail of the battery backup securely
ontop of the phone system's horizatonal edge,
push gently up on the front of the battery backup
until the unit is parallel with the bottom of
the phone system.
|
 |
-
Install three self taping screws through front
of the KSU to secure the battery backup.
- The
battery backup should now be securely fastened
to the phone system. |
 |
-
Run the tail of the battery backup along the left
side of the phone system being careful not to
pinch the tail when replacing the left panel of
the phone system.
|
 |
-Plug
the tail into the ABCS card on the top side of the
phone system. |
 |
-
Once the tail of the battery backup has been plugged
into the ABCS card, the system needs to be tested
using the battery backup's power. To test the battery
backup, take a backup of the system's programming
as a precaution. After the backup is complete, unplug
the phone system from the power supply. The DC light
should remain lit and the system should continue
to work as normal drawing off the power of the battery
backup. The AC light should be dim because of the
loss of the AC power. Once you confirm both of the
LEDs are lit correctly, plug the phone system back
into the wall. Replace all missing external covers
on the phone system. |
